★ 77 device pages approved★ 764 sources cited★ Every fact links to its source★ Send us your build log★ No ads. Some part links may earn us a commission.★ 77 device pages approved★ 764 sources cited★ Every fact links to its source★ Send us your build log★ No ads. Some part links may earn us a commission.
mods for old iconic tech · est. 2026
0000080devices tracked

Home › Devices › Asus › Asus Eee PC 701

[ device photo ]NEW!

ASUS · LAPTOP · 2007

Asus Eee PC 701

Also called: Eee PC 701 · Eee PC 4G · Eee PC 4G Surf · Eee PC 2G Surf · Eee PC 700

✔ APPROVEDChecked fact by fact · last checked 2026-11-16 · 8 sources · 1 item(s) unverified

Asus's late-2007 7-inch netbook that launched the category. Celeron M underclocked to 630 MHz, soldered flash on 2G/4G units, and one DDR2 slot on most 701 boards. Documented changes add a resistive touch overlay, internal USB gadgets, an SD-based storage swap, and alternate OSes.[1][3][2][4]

5MODS
3WORK
2EXPERIMENTAL
8SOURCES

Which one do I have?

MODELS.TXT
ModelVariantYearHow to tell
701 4G4 GB flash, with webcam20077-inch 800×480 screen. Non-Surf 4G units include a webcam and the larger battery pack. Internal flash is soldered.[1]
701 4G Surf4 GB flash, no webcam2007Surf models ship without a webcam and with the smaller 4400 mAh battery. No camera frees an internal USB port for solderless add-ons.[1][5]
700 2G Surf2 GB flash2007Same 7-inch platform with 2 GB soldered flash. Marketing names include 2G Surf.[1]
Specs
Screen7-inch TFT LCD, 800×480 WVGA[1]
CPUIntel Celeron M ULV 353, rated 900 MHz, factory-set to 630 MHz[1]
ChipsetIntel 910GML[1]
Memory0.5 GB DDR2 default; one SO-DIMM socket up to 2 GB on most 701 boards[1]
Storage2 GB or 4 GB soldered SSD on early 700-series; card reader for SD/SDHC/MMC[1]

Mods (5)

⚠ Mod at your own risk. We collect what others have published; we have not tested these mods. Read the safety notes

More RAMWorks
OtherDifficulty: easyOpens caseNo solderingReversible

Most early 701 boards take one DDR2 SO-DIMM. Stock is 512 MB; the socket supports up to 2 GB. Some later white models lack a memory door and need more teardown.[1]

Parts

  • DDR2 SO-DIMM (up to 2 GB) Fits with conditions — Fits the single socket on most 701 boards. Wikipedia notes 700 and 701SDX have soldered RAM instead. Some later white models need full disassembly to reach the slot.[1]

Good to know

  • Most early Eee PCs use 533/667 MHz DDR2 via a standard SO-DIMM that can be swapped.[1]
  • Specs list the 701 4G with 0.5 GB default and one socket up to 2 GB.[1]
  • The 700 and 701SDX have RAM soldered to the motherboard. Some later white models lack a memory access panel.[1]
  • Stock Xandros on the 70x series limits detected RAM to 1 GB even if a larger module is installed; other OSes and the BIOS show full capacity.[1]

Guides:No guide found yet.

Resistive touchscreenWorks
ScreenDifficulty: mediumOpens caseBasic solderingReversible
  • ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.

A 7-inch resistive overlay sits over the LCD with a USB controller board. Kits can tap the webcam USB line or an unused internal header on cameraless Surf models.[3][6][7]

Parts

  • 7-inch resistive touch panel and USB controller Fits — Overlay goes between LCD and bezel. Controller often needs space under the motherboard or a trimmed bezel fit.[3][6]

Good to know

  • A 7-inch touch digitizer mounts between the LCD and the bezel; the ribbon runs to a USB controller.[3]
  • One kit includes the touchpanel, USB controller, and connectors; the controller can plug in line with the USB webcam.[6]
  • Miles Burton reused the camera USB connector for a solder-light install, then extended the short ribbon so the oversized controller could sit under the motherboard.[3]
  • The overlay can make the LCD look slightly murkier.[3]

⚠ Watch out

  • Test which face of the overlay is the touch side before sealing it in place.[3]

Guides:EEE 701 Touchscreen ModificationTouchscreen Kit For Eee PC | HackadayEeePC Touchscreen Retrofit | Hackaday

SD card as storageExperimental
StorageDifficulty: hardOpens caseFine solderingPermanent
  • ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.
  • ⚠ Data loss Can erase what is on the device. Back up first.
  • ⚠ Permanent change Cuts, drills or glues the device. You cannot undo it.

On 2G/4G units the flash is soldered. People use the built-in SD reader as a second drive, or wire an internal SDHC reader in place of the flash for more space.[1][4]

Parts

  • USB SDHC card reader (stripped) and SDHC card Fits with conditions — One write-up strips a cheap USB SDHC reader and mounts a 16 GB card inside after removing the 4 GB flash.[4]

Good to know

  • On 2 GB and 4 GB 700-series models the SSD is permanently soldered to the board.[1]
  • Wikipedia notes users have physically modified the 701 to replace the 4 GB solid-state drive, and cites a Gadgetmix write-up that uses a 16 GB SD card.[1][4]
  • All Eee PC models include a card reader for SD, SDHC, and MMC as extra storage.[1]
  • 8 GB 700-series boards leave the soldered SSD area empty and use a Mini PCIe SSD card instead.[1]

Guides:No guide found yet.

Internal USB devicesExperimental
ConnectivityDifficulty: hardOpens caseBasic solderingReversible
  • ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.

The chipset exposes unused USB data lines on Mini PCIe pads and other board points. Cameraless Surf models can add Bluetooth or a touch controller with no solder. Power should come from a rail that turns off in standby.[2][5][4][1]

Parts

  • USB nano Bluetooth dongle or miniature USB hub Fits with conditions — Surf units without a webcam have a free internal USB header for solderless installs.[2][5][4]

Good to know

  • tnkgrl maps USB signals and 5 V traces that switch off in standby on the 701 motherboard and Mini PCIe slots, for internal devices such as Bluetooth.[2]
  • Inserting a Mini PCIe card in the empty SSD expansion slot can disable the built-in SSD so the machine will not boot from it.[2][1]
  • Hackaday covers solderless storage, Bluetooth, and touch upgrades on 700/701 4G Surf units that lack the webcam and therefore have a free internal USB port.[5]
  • One build runs an internal hub with a flash drive, touchscreen controller, and Bluetooth dongle together.[4] unverified

⚠ Watch out

  • tnkgrl damaged a Bluetooth module while probing a debug connector; probe carefully.[2]

Guides:Modding the Asus 701 (Eee) – tnkgrl MobileNo Solder EEEPC 701 Upgrades | Hackaday

Alternate operating systemsWorks
SoftwareDifficulty: noneCase stays closedNo solderingReversible
  • ⚠ Data loss Can erase what is on the device. Back up first.

Early Eee PCs shipped with Xandros Linux or Windows XP and had no vendor boot lock. Users run other Linux distros and other x86 OSes on the open platform.[1][8]

Good to know

  • Most Eee PC models shipped with Windows XP or a Xandros Linux distribution.[1]
  • Wikipedia lists Linux distros, Android-x86, and other OSes as known to work on most models.[1]
  • Hackaday calls early Eee PCs real full x86 machines without locked-down chipsets or BIOS, suitable for ordinary software.[8]

Guides:No guide found yet.

Sources (8)

SOURCES.TXT