★ 155 device pages approved★ 1835 sources cited★ Every fact links to its source★ Send us your build log★ No ads. Some part links may earn us a commission.★ 155 device pages approved★ 1835 sources cited★ Every fact links to its source★ Send us your build log★ No ads. Some part links may earn us a commission.
mods for old iconic tech · est. 2026
0000161devices tracked

Home › Devices › Apple › iPod mini (2nd generation)

[ device photo ]CUSTOM FW!

APPLE · MUSIC PLAYER · 2005

iPod mini (2nd generation)

Also called: iPod mini 2G · mini 2nd gen · A1051 · Q22B

✔ APPROVEDChecked fact by fact · last checked 2026-11-16 · 19 sources · 2 item(s) unverified

February 2005 Click Wheel mini with 4 GB or 6 GB Microdrive storage, longer battery life than the first gen, and colour-matched wheel lettering. Common mods: CompactFlash instead of the drive, a replacement lithium cell, Rockbox, and iFixit screen or jack swaps.[1][10][16][13]

6MODS
6WORK
0EXPERIMENTAL
19SOURCES

Which one do I have?

MODELS.TXT
ModelVariantYearHow to tell
A10514 GB (silver, blue, pink, green)2005Capacity is laser-etched on the aluminium back. Click-wheel lettering matches the body colour. Order numbers start at M9800 (silver).[2][10][1][11]
A10516 GB (silver, blue, pink, green)2005Same A1051 chassis as the 4 GB; 6 GB is etched on the back. Silver order number M9801.[2][1][10]
Specs
Screen1.67-inch, 138×110 (Gen 2 display part)[9]
Storage (stock)4 GB or 6 GB 1-inch Microdrive (CompactFlash Type II interface)[10][16]
BatteryBuilt-in rechargeable lithium-ion; Apple rates up to 18 hours of playback[1][2]
PortsDock connector (USB 2.0 and FireWire), remote connector, 3.5 mm stereo jack[1]

Mods (6)

⚠ Mod at your own risk. We collect what others have published; we have not tested these mods. Read the safety notes

Rockbox custom firmwareWorks
SoftwareDifficulty: mediumCase stays closedNo solderingReversible
  • ⚠ Can brick A mistake can leave the device unable to start.
  • ⚠ Data loss Can erase what is on the device. Back up first.

Free open-source firmware that dual-boots with Apple's OS. Lifts the stock song limit tied to RAM.[15][13][14][11]

Good to know

  • Rockbox TargetStatus lists iPod Mini as a stable target with no major issues.[15]
  • ipodLoader2 lists the 2nd gen mini (4 GB and 6 GB, capacity engraved on the rear) as supported and can boot Rockbox, the stock OS, or iPod Linux. It is installed with Rockbox's ipodpatcher tool.[13]
  • The Rockbox iPod install manual uses ipodpatcher: press i then Enter to install the bootloader. Confirm the model is supported first. On Windows run ipodpatcher as administrator; on Linux run it as root.[14]
  • The stock song limit comes from RAM; Rockbox bypasses it.[11]

Guides:Rockbox manual: iPod install (ipod_install.tex)

CompactFlash storageWorks
StorageDifficulty: mediumOpens caseNo solderingPermanent20-45 min
  • ⚠ Lithium battery Uses or touches a lithium cell. A damaged cell can catch fire.
  • ⚠ Data loss Can erase what is on the device. Back up first.

The Microdrive uses a CompactFlash Type II connector, so a CF card (or CF-to-SD adapter) can replace the drive. Restore in iTunes after the swap.[16][17][19][18][11]

Special tools: plastic pry tool, heat source for end caps

Good to know

  • The mini's hard drive uses the same connector as CompactFlash cards, so a CF card drops into the bay.[16]
  • After the swap, an iTunes restore reloads Apple's firmware onto the card.[17]
  • Owners have reported 32 GB CF cards (2009 notes) and a 2nd gen with a 64 GB SD card in a CF adapter.[16][18]
  • iPodWiki says 512 GiB is the highest storage tested so far in a mini.[11] unverified
  • iFixit hard-drive guide covers 1st and 2nd gen mini: heat and pry the glued top bezel, then slide the chassis out.[19]

⚠ Watch out

  • Do not unplug the hard-drive flex at the main-board end. That can fracture solder joints and leave the unit in Sad iPod mode.[16]
  • Battery wiring that rubs against the case can spark or overheat. Protect the insulation on reassembly.[16]
  • Use a plastic pry tool on the end caps; the author's metal tool scratched and bent parts.[16]

Guides:iPod Mini Hard Drive Replacement - iFixit Repair GuideiPod Mini CF Mod Tips

Replacement batteryWorks
BatteryDifficulty: mediumOpens caseNo solderingPermanent25-45 min
  • ⚠ Lithium battery Uses or touches a lithium cell. A damaged cell can catch fire.

Open the aluminium case, slide the chassis out, and unplug the built-in lithium cell from the logic board. Aftermarket cells list fit for A1051 4 GB and 6 GB.[3][4][1]

Special tools: #00 Phillips screwdriver, 2.5 mm flathead, spudger, Jimmy

Parts

  • iFixit iPod mini battery (1st and 2nd gen, 550 mAh) Fits — Listed for A1051 2nd gen 4 GB and 6 GB; may be a slightly snugger fit than stock.[4] Buy: ifixit.com

Good to know

  • Apple rates the built-in lithium-ion battery at up to 18 hours of playback. Full charge about 4 hours; about 80% in 2 hours over FireWire.[1]
  • Lock the hold switch before opening. Pull only on the battery connector, not the wires. The top bezel is glued; heat it first.[3]
  • Apple notes rechargeable batteries have a limited number of charge cycles and may need replacing.[1]

⚠ Watch out

  • Original capacity figures conflict across sources (400 / 550 / 650 mAh). Apple publishes hours, not mAh. Treat aftermarket mAh claims with care.[12][4][11] unverified

Guides:iPod Mini Battery Replacement - iFixit Repair Guide

Display replacementWorks
ScreenDifficulty: mediumOpens caseNo solderingPermanent
  • ⚠ Lithium battery Uses or touches a lithium cell. A damaged cell can catch fire.

Replace a cracked or dead display. The Gen 2 panel has a narrower connector than Gen 1.[8][9]

Parts

  • iPod mini Gen 2 display Fits — Connector is narrower than the Gen 1 display. Listed for A1051 4 GB and 6 GB.[9] Buy: ifixit.com

Good to know

  • iFixit display guide covers Gen 1 and Gen 2 parts. Open the case as in the battery guide, then release four white plastic tabs holding the display.[8]
  • The display ribbon connector is fragile.[8]

Guides:iPod Mini Display Replacement - iFixit Repair Guide

Headphone jack boardWorks
AudioDifficulty: mediumOpens caseNo solderingPermanent
  • ⚠ Lithium battery Uses or touches a lithium cell. A damaged cell can catch fire.

Replace the headphone jack board when there is no audio. Same case opening as the battery guide.[7]

Good to know

  • iFixit headphone jack guide: open the case, then lift the jack board off the logic board. Pry near the connector to avoid strain.[7]
  • The jack board connector is fragile. Do not pull on the board at the top of the iPod.[7]

Guides:iPod Mini Headphone Jack Board Replacement - iFixit Repair Guide

Aluminium casing / top bezelWorks
CaseDifficulty: mediumOpens caseNo solderingPermanentabout 1 hour
  • ⚠ Lithium battery Uses or touches a lithium cell. A damaged cell can catch fire.
  • ⚠ Permanent change Cuts, drills or glues the device. You cannot undo it.

Swap the extruded aluminium shell or the glued top plastic bezel after a full chassis slide-out.[5][6]

Good to know

  • Casing guide: lock hold, heat and pry the top bezel, remove the bracket, slide the logic board out, then release the click wheel by pulling back a small black tab while pressing the wheel down.[5]
  • The top bezel is held with adhesive and may need heat and prying in several places.[6]

Guides:iPod Mini Casing Replacement - iFixit Repair GuideiPod Mini Top Bezel Replacement - iFixit Repair Guide

Sources (19)

SOURCES.TXT