Home › Devices › Nintendo › Nintendo DSi
NINTENDO · HANDHELD CONSOLE
Nintendo DSi
Also called: DSi
Nintendo's DSi. Two screens, two cameras, and an SD card slot where the DS Lite had a Game Boy Advance slot. Memory Pit and Unlaunch open it to homebrew; TWiLight Menu++ and the DSpico flashcart run homebrew; a USB-C charge port is also documented.[7][1][3][4][6]
Which one do I have?
Specs
Mods (5)
⚠ Mod at your own risk. We collect what others have published; we have not tested these mods. Read the safety notes
Memory Pit and UnlaunchWorks
- ⚠ Can brick A mistake can leave the device unable to start.
- ⚠ Data loss Can erase what is on the device. Back up first.
- ⚠ Check the law May break a law or rule where you live.
Memory Pit is the entry point that starts homebrew from the SD card. Unlaunch then installs a bootcode on the console so it can autoboot TWiLight Menu++. Dump the NAND first.[1][2]
Good to know
- Memory Pit is the main entry point the guide uses to run homebrew from an SD card.[1]
- Homebrew can run on all DSi consoles, regardless of firmware version or region.[1]
- Make a NAND backup before installing Unlaunch, so a bricked console can be restored.[2]
- Unlaunch is a permanent bootcode installed on the console itself. It gives homebrew full access to the hardware.[2]
- It can be set to autoboot straight into TWiLight Menu++ when the console turns on.[2]
⚠ Watch out
DSpico flashcartWorks
- ⚠ Check the law May break a law or rule where you live.
An open-source DS flashcart built around a Raspberry Pi RP2040. It runs homebrew on the DSi.[4][5]
Parts
- DSpico (RP2040 flashcart) Fits — Open-source hardware. Works in DS, DSi and 3DS systems.[5]
Good to know
- DSpico is an open-source hardware flashcart built on the RP2040 microcontroller. It brings homebrew to DS, DSi and 3DS systems.[5]
- It runs a dedicated app launcher called Pico Launcher.[5]
- The project has separate hardware and firmware repositories, plus a setup guide.[4]
Guides:No guide found yet.
USB-C charging portExperimental
- ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.
- ⚠ Permanent change Cuts, drills or glues the device. You cannot undo it.
A small board replaces the DSi charge connector with a standard USB-C port, so you can charge with a USB-C charger.[6]
Parts
- Giltesa DSi USB-C board Fits — Listed as compatible with the DSi and DSi XL.[6]
Good to know
- The board replaces the original charging connector with a modern, standard USB-C port.[6]
- The maker lists it as compatible with the Nintendo DSi and DSi XL.[6]
Guides:Nintendo DSi: USB-C is a board that allows to replace the original charging connector
Lower LCD and touchscreenWorks
Replace the lower LCD and touchscreen as one assembly. Ribbon cables release from ZIF sockets; a spudger helps pry the panel free.[9]
Good to know
Sources (9)
- docs DSi Guide · 2026-11-14
- docs Installing Unlaunch | DSi Guide · 2026-11-14
- docs DSpico: Documentation repository for the DSpico flashcard · 2026-11-14
- news DSpico: The last flashcart the Nintendo DS will ever need · 2026-11-14
- docs Nintendo DSi: USB-C is a board that allows to replace the original charging connector · 2026-11-14
- docs Nintendo DSi Repair Help · 2026-11-14
- wiki Nintendo DSi - Wikipedia · 2026-11-16
- docs Nintendo DSi Lower LCD Assembly Replacement · 2026-11-16