★ 50 device pages approved★ 482 sources cited★ Every fact links to its source★ Send us your build log★ No ads. Some part links may earn us a commission.★ 50 device pages approved★ 482 sources cited★ Every fact links to its source★ Send us your build log★ No ads. Some part links may earn us a commission.
mods for old iconic tech · est. 2026
0000054devices tracked

Home › Devices › Nintendo › Nintendo DSi

[ device photo ]NEW!

NINTENDO · HANDHELD CONSOLE

Nintendo DSi

Also called: DSi

✔ APPROVEDChecked fact by fact · last checked 2026-11-16 · 9 sources · 1 item(s) unverified

Nintendo's DSi. Two screens, two cameras, and an SD card slot where the DS Lite had a Game Boy Advance slot. Memory Pit and Unlaunch open it to homebrew; TWiLight Menu++ and the DSpico flashcart run homebrew; a USB-C charge port is also documented.[7][1][3][4][6]

5MODS
4WORK
1EXPERIMENTAL
9SOURCES

Which one do I have?

MODELS.TXT
ModelVariantYearHow to tell
TWL-001DSi—Standard DSi. Two 3.25-inch screens and two cameras. No Game Boy Advance slot; SD card slot instead.[7][8] unverified
Specs
ScreensTwo 3.25-inch TFT LCDs[7][8]
Battery840 mAh internal rechargeable[7][8]
StorageInternal SD card slot (SDHC up to 32 GB); no GBA cartridge slot[7][8]

Mods (5)

⚠ Mod at your own risk. We collect what others have published; we have not tested these mods. Read the safety notes

Memory Pit and UnlaunchWorks
SoftwareDifficulty: hardCase stays closedNo solderingPermanent
  • ⚠ Can brick A mistake can leave the device unable to start.
  • ⚠ Data loss Can erase what is on the device. Back up first.

Memory Pit is the entry point that starts homebrew from the SD card. Unlaunch then installs a bootcode on the console so it can autoboot TWiLight Menu++. Dump the NAND first.[1][2]

Good to know

  • Memory Pit is the main entry point the guide uses to run homebrew from an SD card.[1]
  • Homebrew can run on all DSi consoles, regardless of firmware version or region.[1]
  • Make a NAND backup before installing Unlaunch, so a bricked console can be restored.[2]
  • Unlaunch is a permanent bootcode installed on the console itself. It gives homebrew full access to the hardware.[2]
  • It can be set to autoboot straight into TWiLight Menu++ when the console turns on.[2]

⚠ Watch out

  • Unlaunch writes to the console's NAND, so there is a small chance to brick the console. Dump a clean NAND first.[2][1]

Guides:DSi GuideInstalling Unlaunch | DSi Guide

TWiLight Menu++Works
SoftwareDifficulty: mediumCase stays closedNo solderingReversible

An open-source menu that can replace the DSi menu and launch a variety of applications.[3]

Good to know

  • TWiLight Menu++ is an open-source menu that launches a variety of applications. It is an all-in-one replacement menu for the Nintendo DS and 3DS family.[3]

Guides:TWiLight Menu++ | DS-Homebrew Wiki

DSpico flashcartWorks
StorageDifficulty: easyCase stays closedNo solderingReversible

An open-source DS flashcart built around a Raspberry Pi RP2040. It runs homebrew on the DSi.[4][5]

Parts

  • DSpico (RP2040 flashcart) Fits — Open-source hardware. Works in DS, DSi and 3DS systems.[5]

Good to know

  • DSpico is an open-source hardware flashcart built on the RP2040 microcontroller. It brings homebrew to DS, DSi and 3DS systems.[5]
  • It runs a dedicated app launcher called Pico Launcher.[5]
  • The project has separate hardware and firmware repositories, plus a setup guide.[4]

Guides:No guide found yet.

USB-C charging portExperimental
ChargingDifficulty: expertOpens caseFine solderingPermanent
  • ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.
  • ⚠ Permanent change Cuts, drills or glues the device. You cannot undo it.

A small board replaces the DSi charge connector with a standard USB-C port, so you can charge with a USB-C charger.[6]

Parts

  • Giltesa DSi USB-C board Fits — Listed as compatible with the DSi and DSi XL.[6]

Good to know

  • The board replaces the original charging connector with a modern, standard USB-C port.[6]
  • The maker lists it as compatible with the Nintendo DSi and DSi XL.[6]

Guides:Nintendo DSi: USB-C is a board that allows to replace the original charging connector

Lower LCD and touchscreenWorks
RepairDifficulty: hardOpens caseNo solderingReversible

Replace the lower LCD and touchscreen as one assembly. Ribbon cables release from ZIF sockets; a spudger helps pry the panel free.[9]

Good to know

  • iFixit's guide removes the lower LCD and lower touchscreen as one unit.[9]
  • The guide covers ribbon-cable release from ZIF sockets and spudger prying steps.[9]

Guides:Nintendo DSi Lower LCD Assembly Replacement

Sources (9)

SOURCES.TXT