Home › Devices › Nintendo › Nintendo Switch
NINTENDO · HANDHELD CONSOLE · 2017
Nintendo Switch
Also called: Switch · HAC-001 · HAC-001(-01) · Mariko
Nintendo's hybrid console (March 2017). Unpatched V1 units can run Atmosphere by injecting a USB payload in Recovery Mode. Patched hardware needs a modchip. Joy-Con sticks and the internal battery are documented repairs.[1][2][3][6][9][8]
Which one do I have?
| Model | Variant | Year | How to tell |
|---|---|---|---|
| HAC-001 | Unpatched V1 | 2017 | Early units open to the Fusee Gelee bootROM bug. An RCM jig and USB payload can launch custom firmware without a modchip.[2][3][6] |
| HAC-001 | Patched V1 | 2018 | Later V1 hardware with the bootROM bug closed. Softmod via RCM does not work; these need a hardware modchip.[3][6] |
| HAC-001(-01) | 2019 revision | — | Revised 2019 model with an improved Tegra X1 chip, sold as HAC-001(-01).[1][8] |
Specs
Mods (4)
⚠ Mod at your own risk. We collect what others have published; we have not tested these mods. Read the safety notes
Atmosphere on an unpatched V1Works
- ⚠ Can brick A mistake can leave the device unable to start.
- ⚠ Account ban Online services may ban the device or account.
- ⚠ Check the law May break a law or rule where you live.
- ⚠ Data loss Can erase what is on the device. Back up first.
On an unpatched V1, an RCM jig in the right Joy-Con rail enters Recovery Mode and a USB payload starts Hekate or Atmosphere before Horizon boots. Atmosphere supports an emulated NAND (emuMMC) on the SD card.[2][3][4][5][6]
Parts
- RCM jig Fits with conditions — Sits in the right Joy-Con rail to enter Recovery Mode. Unpatched V1 only.[2]
Good to know
- Unpatched V1 units use a Tegra X1 bootROM bug (Fusee Gelee). An RCM jig in the right Joy-Con rail enters Recovery Mode, then a USB payload is injected before Horizon starts.[2][3][6]
- Atmosphere is modular custom firmware that patches Horizon on the fly. It provides customized system modules, cheats, themes, sysmodules, and title redirection for homebrew.[4][3]
- Atmosphere supports an emulated NAND (emuMMC) on the microSD card. Guides describe partitioning the card for emuMMC to keep stock SysNAND separate.[2][4]
- Hekate is a GUI bootloader for launching payloads, raw eMMC backup/restore, hardware diagnostics, SD partitioning, and AutoRCM.[5]
- Patched units close the bootROM bug and need hardware installed beforehand (a modchip) instead of this softmod.[3][6]
⚠ Watch out
Guides:The Ultimate Noob Guide for Hacking your Nintendo SwitchNH Switch Guide
Modchip for patched consolesWorks
- ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.
- ⚠ Can brick A mistake can leave the device unable to start.
- ⚠ Permanent change Cuts, drills or glues the device. You cannot undo it.
- ⚠ Account ban Online services may ban the device or account.
- ⚠ Check the law May break a law or rule where you live.
Patched consoles cannot use the RCM softmod. The install guide says they need specialized hardware installed first, such as a modchip, before custom firmware can run.[3][6]
Parts
- Switch modchip (patched units) Fits with conditions — Needed on units where the Tegra bootROM exploit is patched.[3]
Good to know
- New Switch consoles appeared in 2018 with the Nvidia Tegra hardware exploit patched; older units still work.[6]
- The guide says it works on V1 unpatched and modchipped consoles; other (patched) consoles need specialized hardware installed beforehand.[3]
Guides:No guide found yet.
Joy-Con joystick replacementWorks
- ⚠ Lithium battery Uses or touches a lithium cell. A damaged cell can catch fire.
Replace a drifting Joy-Con stick module. iFixit documents opening the Joy-Con, disconnecting the battery and ribbons, and swapping the potentiometer module. iFixit also offers an aftermarket GuliKit TMR stick as an alternative.[9]
Special tools: Tri-point Y00 and Phillips #00 screwdrivers, spudger, tweezers
Good to know
Replace the Switch batteryWorks
- ⚠ Lithium battery Uses or touches a lithium cell. A damaged cell can catch fire.
Swap the internal lithium pack. Discharge below 25% first. Needs a Tri-point Y00 for the rear case and isopropyl alcohol for the adhesive under the cell.[8][7]
Special tools: Tri-point Y00, JIS 00, isopropyl alcohol
Good to know
Buttons & modes
| What | How |
|---|---|
| Recovery Mode payload (unpatched V1) | Fit an RCM jig in the right Joy-Con rail, then send a Fusee Gelee payload over USB before the OS boots.[2] |
Sources (9)
- wiki Nintendo Switch - Wikipedia · 2026-11-16
- docs The Ultimate Noob Guide for Hacking your Nintendo Switch · 2026-11-16
- docs NH Switch Guide · 2026-11-16
- docs Atmosphere - Atmosphere-NX · 2026-11-16
- docs hekate - CTCaer · 2026-11-16
- news Switch hardware update blocks tegra exploits – RetroRGB · 2026-11-16
- docs Nintendo Switch Teardown - iFixit · 2026-11-16
- docs Nintendo Switch Battery Replacement - iFixit · 2026-11-16
- docs Left Joy-Con Joystick Replacement - iFixit · 2026-11-16