★ 93 device pages approved★ 980 sources cited★ Every fact links to its source★ Send us your build log★ No ads. Some part links may earn us a commission.★ 93 device pages approved★ 980 sources cited★ Every fact links to its source★ Send us your build log★ No ads. Some part links may earn us a commission.
mods for old iconic tech · est. 2026
0000096devices tracked

Home › Devices › Nokia › Nokia N900

[ device photo ]NEW!

NOKIA · PHONE · 2009

Nokia N900

Also called: RX-51 · RM-680 · RM-696 · Rover

✔ APPROVEDChecked fact by fact · last checked 2026-11-16 · 13 sources · 4 item(s) unverified

2009 Maemo Linux slider phone (RX-51) with a hardware keyboard, 32 GB internal storage, and a removable pack. Community work boots Maemo Leste or postmarketOS from microSD via U-Boot, and makers have fitted USB-C plus a supercapacitor fake battery when the original cell is dead.[4][6][1][12]

7MODS
4WORK
3EXPERIMENTAL
13SOURCES

Which one do I have?

MODELS.TXT
ModelVariantYearHow to tell
RM-680 / RM-696Nokia N900 (RX-51 / Rover)2009Announced 2 September 2009. 0xFFFF flasher lists RX-51 with model numbers RM-680 and RM-696. Codename Rover / RX-51.[4][12]
Specs
CPU / RAMTI OMAP 3430 600 MHz; 256 MB RAM[11]
Storage32 GB internal SSD; microSD slot (launch announcement: expandable to 48 GB)[11][13]
BatteryAbout 1320 mAh / 4.9 Wh; bq27200 fuel gauge[4][11]

Mods (7)

⚠ Mod at your own risk. We collect what others have published; we have not tested these mods. Read the safety notes

Maemo Leste on microSDWorks
SoftwareDifficulty: mediumCase stays closedNo solderingReversible
  • ⚠ Can brick A mistake can leave the device unable to start.
  • ⚠ Data loss Can erase what is on the device. Back up first.

Write a Maemo Leste image to a fast microSD card, flash U-Boot, and boot Linux from the card while keeping the phone usable as a community OS.[4][5][3]

Good to know

  • Install is two steps: copy the image to a microSD card, then set up U-Boot on the phone.[4][5]
  • An SDXC U3 microSD card is required; class 10 U1 cards are too slow.[4]
  • After first boot, expand the root partition to fill the SD card. Images newer than 17 January 2021 disable root SSH by default.[5]
  • Speakers are enabled by default; be careful of very high frequencies and levels.[4]

Guides:Getting Started - Maemo Leste WikiNokia N900 - Maemo Leste Wiki

U-Boot SD-card bootWorks
SoftwareDifficulty: mediumCase stays closedNo solderingReversible
  • ⚠ Can brick A mistake can leave the device unable to start.
  • ⚠ Data loss Can erase what is on the device. Back up first.

Flash or load U-Boot so the N900 boots kernels and scripts from the external microSD card (with the keyboard open, SD is tried first).[6][4][3]

Good to know

  • Default boot order: with the keyboard closed, an attached kernel image boots; otherwise U-Boot tries the external SD card, then internal eMMC.[6]
  • Boot scripts load uImage, zImage, or boot.scr from a FAT or ext2/3/4 partition on the SD card.[6]
  • The Nokia flasher and open-source 0xFFFF flasher prepend the required NOLO header when flashing.[6]
  • U-Boot can be loaded over USB to RAM as a test without flashing.[6]

Guides:Nokia RX-51 aka N900 — Das U-Boot documentationNokia N900 - Maemo Leste Wiki

postmarketOS (sdcard / U-Boot)Experimental
SoftwareDifficulty: hardCase stays closedNo solderingReversible
  • ⚠ Can brick A mistake can leave the device unable to start.
  • ⚠ Data loss Can erase what is on the device. Back up first.

Community Linux port for RX-51. Booting, framebuffer, keyboard unlock, and backlight work; the keymap is wrong and Wi-Fi needs extra firmware.[7]

Good to know

  • Booting the system, kernel log, framebuffer, keyboard unlock of the root partition, and backlight control are listed as working.[7]
  • Virtual terminal keymap is incorrect; the shift key does not allow entering numbers.[7]
  • Wi-Fi needs the linux-firmware package for the wl1251 chip.[7]
  • Typical setup uses sdcard boot from U-Boot's bootmenu.[7]

Guides:No guide found yet.

Supercapacitor fake batteryExperimental
BatteryDifficulty: hardOpens caseBasic solderingPermanent
  • ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.
  • ⚠ Can brick A mistake can leave the device unable to start.
  • ⚠ Data loss Can erase what is on the device. Back up first.
  • ⚠ Permanent change Cuts, drills or glues the device. You cannot undo it.

When the original cell is dead, a supercapacitor pack with temperature-sense resistors can power the phone from an external supply or USB-C charge path.[1][2][3]

Good to know

  • A large supercapacitor on the battery pins plus a +5V source can boot the phone; resistors between the third pin and ground emulate the temperature sensor.[1][2]
  • A refined build reused the original battery connector for the fake pack.[2]
  • Original-type packs referenced by the builder are BL-5J style.[1] unverified

⚠ Watch out

  • The builder corrupted the installed OS and suspects supplying +5V instead of the expected +4.2V to the battery pins, or a sudden battery pull.[1]

Guides:Nokia N900 Necromancy

USB-C port in the micro-USB openingExperimental
ChargingDifficulty: hardOpens caseFine solderingPermanent
  • ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.
  • ⚠ Permanent change Cuts, drills or glues the device. You cannot undo it.

Fit a 6-pin USB-C receptacle into the sanded micro-USB opening. Without pull-down / PD identifiers, many chargers will not negotiate power.[1][2][3]

Good to know

  • A 6-pin USB-C port was cut and sanded to fit in the original micro-USB spot.[1]
  • Without pull-down resistors the port only works with a dumb USB-A-to-USB-C cable at default 0.5A.[1]
  • Chargers with power delivery cannot identify such ports and will not provide power.[1][2]

⚠ Watch out

  • The board's +5V pad can rip off; the builder notes it is the only +5V connection besides the pads under the USB port.[1]

Guides:Nokia N900 Necromancy

Stock USB port replacementWorks
RepairDifficulty: hardOpens caseFine solderingReversible
  • ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.

iFixit guide to open the phone and lift the motherboard out to reach the micro-USB port on the board. The guide covers disassembly only.[9][8]

Special tools: plastic opening tool

Good to know

  • Disassembly starts face-down; a plastic tool lifts the motherboard out of the back cover to reach the USB port at the bottom of the board.[9]

Guides:Nokia N900 USB Replacement - iFixit Repair Guide

Separate slider / keyboard halfWorks
RepairDifficulty: mediumOpens caseNo solderingReversible

Remove the battery and screws so the screen half separates from the keyboard half (slider assembly). Prerequisite for deeper board work; not a full keyboard or screen swap guide.[10][8]

Good to know

  • Remove the battery first, then the screws that free the B-cover; work with the screen face down to separate the halves.[10]

Guides:Nokia N900 Slider Assembly Replacement - iFixit Repair Guide

Sources (13)

SOURCES.TXT