★ 141 device pages approved★ 1634 sources cited★ Every fact links to its source★ Send us your build log★ No ads. Some part links may earn us a commission.★ 141 device pages approved★ 1634 sources cited★ Every fact links to its source★ Send us your build log★ No ads. Some part links may earn us a commission.
mods for old iconic tech · est. 2026
0000147devices tracked

Home › Devices › Olympus › Olympus Trip 35

Olympus Trip 35NEW!

Photo: Michael Gatchell, CC BY 2.0 · AI-edited (studio background)

OLYMPUS · CAMERA · 1967-1984

Olympus Trip 35

Also called: Trip 35 · Olympus Trip

✔ APPROVEDChecked fact by fact · last checked 2026-11-16 · 10 sources · 1 item(s) unverified

Battery-free 35mm compact with a selenium meter and two shutter speeds. Common work is cleaning sticky aperture and shutter blades; deeper mods add manual speed and aperture control or boost the meter for faster film.[5][7][2][1][4]

3MODS
2WORK
1EXPERIMENTAL
10SOURCES

Which one do I have?

MODELS.TXT
ModelVariantYearHow to tell
Trip 35Early (max ASA 200)1967First few years of production. Film-speed dial tops out at ASA 200.[5][10]
Trip 35Later (max ASA 400)—Later production. Film-speed dial goes to ASA 400.[5][7][6]
Specs
Film35mm full-frame[6][5]
Shutter1/40 or 1/200, chosen automatically (or by flash mode)[5][7][9][8]
Film speed dialASA 25–400 (earlier cameras max ASA 200)[7][5]
PowerNo battery; selenium cell around the lens meters exposure[5][7]

Mods (3)

⚠ Mod at your own risk. We collect what others have published; we have not tested these mods. Read the safety notes

Clean sticky aperture and shutter bladesWorks
RepairDifficulty: mediumOpens caseNo solderingReversible

Oil that creeps onto the blades makes them sluggish or stuck. Remove the front lens group and clean each blade; the shutter often works again without other mods.[2][3][8]

Special tools: jeweller's screwdriver set

Good to know

  • Oil on the blades is the usual cause of sticky aperture or shutter action.[2][3]
  • Electronics cleaner works; lighter fluid also works but dries slowly.[2]
  • A Trip that will not raise the red low-light flag may still have a working meter; gummed blades are a common fault instead.[8]
  • Mark the lens threads before reassembly so the front group goes back in the same position.[2]

⚠ Watch out

  • Do not push a blade toward its hinge when cleaning; pull each blade through a cloth sandwich.[2]

Guides:Cleaning Aperture and Shutter Blades on the Trip 35 and Pen Family

Manual shutter speed and apertureWorks
Buttons & inputDifficulty: hardOpens caseBasic solderingPermanent
  • ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.
  • ⚠ Permanent change Cuts, drills or glues the device. You cannot undo it.

Cut the meter link and reshape the speed lever so you choose 1/40 or 1/200 by flipping the camera, and set aperture by hand. Automatic exposure is gone after this.[1][5]

Special tools: jeweller's screwdriver set, soldering iron

Good to know

  • After the mod the camera is manual-only; automatic exposure is lost.[1]
  • Speed is chosen by turning the camera upside down: 1/200 with the flash connector up, 1/40 with it down.[1]
  • The stock shutter only has 1/40 and 1/200; this mod does not add 1/125 or 1/30.[1][5]

⚠ Watch out

  • Practise on a junk camera before working on one you care about.[1]
  • Do not unsolder the black flash-sync wire at the hot shoe; the plastic melts.[1]

Guides:Adding Manual Shutter-Speed Control to the Olympus Trip 35 (and Pen EE cameras)

Meter boost for ISO 3200 filmExperimental
OpticsDifficulty: hardOpens caseBasic solderingPermanent
  • ⚠ Lithium battery Uses or touches a lithium cell. A damaged cell can catch fire.
  • ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.
  • ⚠ Permanent change Cuts, drills or glues the device. You cannot undo it.

A small circuit powered by a CR3032 coin cell boosts the selenium meter output so auto exposure can handle film around ISO 3200. One published build; still experimental.[4]

Special tools: soldering iron, drill

Parts

  • CR3032 coin cell Fits with conditions — Powers the boost circuit in the published build; housing was improvised from a film canister.[4]

Good to know

  • The stock meter is designed for film up to ISO 400.[4]
  • The published build uses a CR3032-powered circuit for about three stops of extra meter speed.[4]
  • The build drilled the baseplate, cut wires, and used a part from a broken donor camera.[4]
  • The author's test roll (Ilford Delta 3200) came out about a stop under.[4]

⚠ Watch out

  • The coin-cell housing in the published build was improvised and hung from wires; treat it as a prototype.[4]

Guides:Modifying an Olympus Trip 35 for Shooting ISO 3200 Film

Sources (10)

SOURCES.TXT