Home › Devices › Apple › PowerBook 100
APPLE · LAPTOP · 1991
PowerBook 100
Also called: PB100 · Macintosh PowerBook 100 · M1506 · Apple PowerBook 100
Sony-designed 68000 PowerBook (model M1506) with a lead-acid battery and 40-pin 2.5-inch SCSI. Almost every unit needs a capacitor recap; common upgrades replace the Conner drive with BlueSCSI or SCSI2SD flash, and builders make lithium drop-in battery packs.[2][1][6][11][5]
Which one do I have?
Specs
| CPU | 16 MHz Motorola 68000; the only PowerBook with a 68000[1][2] |
| Display | 9-inch monochrome passive-matrix; Sharp LM64P791 panel; 640×400[1][10][9] |
| RAM | 2 MB on board; one proprietary 70-pin 100 ns PSRAM slot; max 8 MB[1][2] |
| Storage | 2.5-inch SCSI (40-pin), adapter required; stock 20 MB or 40 MB; no internal floppy[2][1][10] |
| Battery | Sealed lead-acid main pack (unique among PowerBooks); CMOS backup 2× CR2430 (user-replaceable)[1][2][3] |
| OS | System 6.0.8L original; supported 7.0.1–7.5.1 and 7.5.3–7.5.5[1] |
| Sound | One 8-bit mono sound out[1] |
Mods (6)
⚠ Mod at your own risk. We collect what others have published; we have not tested these mods. Read the safety notes
Conner sticky bumper tape fixWorks
- ⚠ Data loss Can erase what is on the device. Back up first.
Early Conner 2.5-inch SCSI drives park against a rubber bumper that turns to goo. A piece of tape over the bumper can free the heads if the rest of the drive is healthy.[14][2][13][7]
Good to know
- Nearly every stock PowerBook 100 uses a Conner drive unless it was replaced.[14][2]
- Early Conner drives have a rubber bumper that turns sticky; a piece of tape over the bumper can get them working again if nothing else is wrong.[14]
- The bumper that sticks is under the platter — the head rests on it when parked — so the drive must be opened.[13]
- One 2022 restore taped the bumper and the drive still spun without seeking — tape is not a sure fix.[7] unverified
- Later Conner drives have no rubber bumper; a dead one of that type is probably just dead.[14]
⚠ Watch out
- Keep backups of anything important on the drive. Initiator-mode tools can copy a still-working drive to SD.[13]
Guides:No guide found yet.
BlueSCSI / SCSI2SD flash storageWorks
- ⚠ Data loss Can erase what is on the device. Back up first.
Replace the aging Conner SCSI drive with a BlueSCSI, ZuluSCSI, or SCSI2SD board on the internal 40-pin connector (adapter board required).[11][12][2][10][13]
Parts
- BlueSCSI (STM32 SCSI emulator) Fits with conditions — Needs the 40-pin PowerBook adapter. The adapter was tested in a 520c and did not work in a 145; fit in the PB100 is unconfirmed. Enable termination for internal use; do not seat the ribbon fully on J1.[11][12][2]
- BlueSCSI PowerBook 40-pin adapter (v1.1) Fits with conditions — Board v1.0 has a power fault; v1.1 is recommended. MacDat lists the PB100 drive connector as 40-pin; check your cable before buying.[12][2]
- SCSI2SD replacement drive Fits — Documented installed in place of a 40 MB Conner CP2045 in one teardown unit.[10]
Good to know
- BlueSCSI is an open-source SD-card replacement for old SCSI drives; initiator mode can image a vintage drive to SD.[11][13]
- MacDat lists ZuluSCSI, BlueSCSI, or similar as the alternative to repairing the Conner bumper.[2]
- The internal connector is 2.5-inch SCSI (40-pin) and needs an adapter.[2]
- The 40-pin PowerBook adapter must have termination enabled to work as the internal drive, and the ribbon should not be seated fully on connector J1.[12]
Guides:No guide found yet.
6 MB SRAM expansion (8 MB total)Works
Fill the single proprietary PSRAM slot with a 6 MB card (or modern SRAM module) to reach the 8 MB maximum.[1][2][9][15]
Parts
- PurpleRAM 6 MB SRAM module (Jurassic Computing) Fits — Compatible with the PowerBook 100 per the seller, who claims lower power use than PSRAM. Cards from other PowerBook models are a different physical size and will not fit.[15][2] Buy: tindie.com
Good to know
- Stock is 2 MB on board with one 70-pin 100 ns PSRAM slot; cards from other models will not fit.[1][2]
- RAM can be expanded to 8 MB with a 6 MB module.[9][15]
- PurpleRAM uses SRAM instead of PSRAM and the seller says it needs no refresh and uses about a third of the power.[15] unverified
Guides:No guide found yet.
SCSI-Ethernet networkingWorks
Apple never sold Ethernet for this machine. Plug a SCSI-Ethernet adapter into the HDI-30 port (often powered from ADB) for wired networking; Wi-Fi can ride on top of that.[9][8]
Parts
- Asante Micro EN/SC (or similar SCSI-Ethernet) Fits — Plugs into the external SCSI port and draws power from the ADB port in the documented build.[9]
Good to know
- The PowerBook 100 never had Ethernet and Apple never sold an Ethernet option; a SCSI-Ethernet adapter is the practical route.[9]
- One working build used an Asante Micro EN/SC on the SCSI port with ADB power, then browsed with NCSA Mosaic under System 7.0.1 / 7.1.[9]
- The external SCSI port is an HDI-30 (30-pin) connector. SCSI Disk Mode is supported; leave it by pressing both buttons on the left side.[8]
Guides:The Wireless PowerBook 100
Recap logic board, LCD, and inverterWorks
- ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.
- ⚠ Permanent change Cuts, drills or glues the device. You cannot undo it.
Surface-mount electrolytics leak on every unit. Replace the logic-board, LCD, and backlight-inverter caps (tantalum where they fit) to restore a blank or flaky machine.[2][6][7][16]
Good to know
- Surface-mount electrolytic capacitors leak and affect every PowerBook 100.[2]
- Replacing the caps on the logic board and LCD usually restores function, but corrosion may remain.[2]
- Two of three inductors near C20, C25, C26 and C21 can be corroded and are linked to LCD voltage (two are 150 µH).[2]
- A full write-up rates the job moderate-to-hard and prefers tantalums where available; the backlight inverter has two electrolytics that should be done too.[6]
- A 2022 restore of a dead blank-screen unit booted after a full recap; sound stayed dead, which the author blamed on two logic-board caps not yet fitted.[7]
⚠ Watch out
Guides:Repair: Apple Macintosh PowerBook 100 "Gotta re-cap 'em all!" | Gough's Tech Zone
Lithium drop-in main batteryExperimental
- ⚠ Lithium battery Uses or touches a lithium cell. A damaged cell can catch fire.
- ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.
Original SLA cells are out of production. Builders fit Li-Po packs with a custom BMS that still work with the stock charger (with limits).[5][3][4]
Good to know
- Original lead-acid cells are no longer made, so any rebuild needs new cells or a third-party pack.[3][4]
- One build used two Li-Po pouch cells (~7.2 V nominal) in place of the four-cell SLA pack.[5]
- The stock charger cannot fully charge the Li-Po cells to 8.4 V; that build used relays to switch each cell to its own charger under 80 percent.[5]
- Pulling the power adapter while those cells are on charge cuts all power to the laptop.[5]
- A custom BMS and Li-Po pack has been sold on eBay by a 68kMLA member.[3] unverified
- Do not solder lithium cells with an iron — use a spot welder; thermal runaway is the risk.[3]
- The PowerBook 100 pack is not interchangeable with the NiCad packs used in the 140–180c line.[3][4]
⚠ Watch out
- Lead-acid cells must be kept charged or they are ruined — do not leave a stock pack discharged in storage.[4]
Guides:Upgrading The PowerBook 100 With A Fresh New Battery | Hackaday
Buttons & modes
Sources (16)
- docs PowerBook 100 Specs: EveryMac.com · 2026-11-17
- docs Apple PowerBook 100 - MacDat · 2026-11-17
- docs PowerBook Battery Rebuild Info - MacDat · 2026-11-17
- blog DIY PowerBook 100 Battery: The Carpenter's Trade in the Computer Age · 2026-11-17
- news Upgrading The PowerBook 100 With A Fresh New Battery | Hackaday · 2026-11-17
- blog Repair: Apple Macintosh PowerBook 100 "Gotta re-cap 'em all!" | Gough's Tech Zone · 2026-11-17
- forum Here we go again... (PowerBook 100 Recap/Restore) | TinkerDifferent · 2026-11-17
- docs Connecting SCSI devices and using SCSI Target Mode for PowerBooks | TinkerDifferent · 2026-11-17
- blog The Wireless PowerBook 100 · 2026-11-17
- blog Apple Macintosh Powerbook 100 - Old Crap Vintage Computing · 2026-11-17
- official BlueSCSI - The Future of Retro SCSI · 2026-11-17
- official bluescsi_pb: Use BlueSCSI in the Apple PowerBook (40-pin adapter) · 2026-11-17
- blog The gooey rubber that's slowly ruining old hard drives · 2026-11-17
- docs List of 2.5" SCSI Hard Drive Manufacturers - MacDat · 2026-11-17
- shop PurpleRAM 6MB memory module for PowerBook 100 - Tindie · 2026-11-17
- forum Powerbook 100 brightness control | Applefritter · 2026-11-17