★ 215 device pages approved★ 2630 sources cited★ Every fact links to its source★ Send us your build log★ No ads. Some part links may earn us a commission.★ 215 device pages approved★ 2630 sources cited★ Every fact links to its source★ Send us your build log★ No ads. Some part links may earn us a commission.
mods for old iconic tech · est. 2026
0000221devices tracked

Home › Devices › Sony › Sony ICF-SW35

[ device photo ]NEW!

SONY · RADIO · 1999

Sony ICF-SW35

Also called: ICF-SW35 · ICF-SW35(JE) · Sony world band receiver

✔ APPROVEDChecked fact by fact · last checked 2026-11-17 · 7 sources · 9 item(s) unverified

A pocket world-band radio with 50 memories, an attenuator, and a backlit display. Two written mods remove the keypad beep or add a brighter backlight. It also has a 4.5 V DC jack.[4][2][3][5][6][7]

3MODS
0WORK
3EXPERIMENTAL
7SOURCES

Which one do I have?

MODELS.TXT
ModelVariantYearHow to tell
ICF-SW35ICF-SW35(JE)1999Look for ICF-SW35 on the case. Sony's overseas list uses ICF-SW35(JE). The manual is copyright 1999. Made 2000–2018 per RigPix, now discontinued.[1][2][4][3]
Specs
BandsFM 76–108 MHz, stereo in the earphones. AM 150–29995 kHz (LW, MW, and SW).[4]
Memories50[4]
Power4.5 V DC only. Three AA (R6) cells, or the rear DC IN 4.5 V jack.[2][3]
Battery lifeJEITA table: R6 cells about 12 h on SW and 17 h on FM. Sony LR6 alkaline about 33 h on SW and 46 h on FM.[2]
Speaker240 mW at 10% distortion into 8 ohm, with an external speaker connector[3]
Headphone jack3.5 mm stereo, 16 ohm[2]
Size168 × 106 × 35 mm, 405 g[3]

Mods (3)

⚠ Mod at your own risk. We collect what others have published; we have not tested these mods. Read the safety notes

External 4.5 V powerExperimental
ChargingDifficulty: easyCase stays closedNo solderingReversible

The rear jack takes 4.5 V DC on a positive-tip coaxial plug. The plug size is not confirmed. Treat this as untested.[7][2][1][3]

Parts

  • 4.5 V DC supply, positive-tip coaxial plug Fits with conditions — Keep the supply at or below 4.5 V. The plug diameter is not confirmed. A 12 V to 4.5 V converter (Sony DCC-E345) and a three-D-cell holder are only suggestions.[7]

Good to know

  • The manual says to power the set with 4.5 V DC only. The rear jack is marked DC IN 4.5 V. Stock cells are three AA.[2]
  • The external plug is coaxial with a positive tip. The voltage tolerance is unknown, so stay at or below 4.5 V.[7] unverified

⚠ Watch out

  • The plug size is unconfirmed. A wrong plug or more than 4.5 V is untested.[7] unverified

Guides:No guide found yet.

Remove the keypad beepExperimental
AudioDifficulty: mediumOpens caseBasic solderingReversible
  • ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.

One builder silenced the beep by taking out a single capacitor. Which capacitor is shown only in the photos.[5]

Good to know

  • The beep mod is removing one capacitor. The part number and value are not stated.[5] unverified

⚠ Watch out

  • Match the capacitor to the photos on the build post. The text does not identify it.[5] unverified

Guides:Rolf's Sony ICF-SW35 mod removes the beep sound

Brighter LED backlightExperimental
ScreenDifficulty: hardOpens caseFine solderingReversible
  • ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.

Add a 120 kilohm resistor and a bright LED at pin 10. The existing backlight capacitor stays. The light follows the backlight button, including a short glow with the radio off.[6]

Parts

  • 120 kilohm resistor and a bright LED Fits with conditions — The LED goes at pin 10. LED type, polarity and wire path are shown only in the photos, if at all.[6]

Good to know

  • The build adds a 120 kilohm resistor and a bright LED at pin 10. The backlight capacitor does not need to be replaced.[6] unverified
  • Pressing the backlight switch keeps the light on. With the radio off, that switch holds the light for about 15 seconds.[6] unverified

Guides:Rolf's LED backlight mod for the Sony ICF-SW35

Sources (7)

SOURCES.TXT