Home › Devices › Sony › Sony ICF-SW35
SONY · RADIO · 1999
Sony ICF-SW35
Also called: ICF-SW35 · ICF-SW35(JE) · Sony world band receiver
A pocket world-band radio with 50 memories, an attenuator, and a backlit display. Two written mods remove the keypad beep or add a brighter backlight. It also has a 4.5 V DC jack.[4][2][3][5][6][7]
Which one do I have?
Specs
| Bands | FM 76–108 MHz, stereo in the earphones. AM 150–29995 kHz (LW, MW, and SW).[4] |
| Memories | 50[4] |
| Power | 4.5 V DC only. Three AA (R6) cells, or the rear DC IN 4.5 V jack.[2][3] |
| Battery life | JEITA table: R6 cells about 12 h on SW and 17 h on FM. Sony LR6 alkaline about 33 h on SW and 46 h on FM.[2] |
| Speaker | 240 mW at 10% distortion into 8 ohm, with an external speaker connector[3] |
| Headphone jack | 3.5 mm stereo, 16 ohm[2] |
| Size | 168 × 106 × 35 mm, 405 g[3] |
Mods (3)
⚠ Mod at your own risk. We collect what others have published; we have not tested these mods. Read the safety notes
External 4.5 V powerExperimental
The rear jack takes 4.5 V DC on a positive-tip coaxial plug. The plug size is not confirmed. Treat this as untested.[7][2][1][3]
Parts
- 4.5 V DC supply, positive-tip coaxial plug Fits with conditions — Keep the supply at or below 4.5 V. The plug diameter is not confirmed. A 12 V to 4.5 V converter (Sony DCC-E345) and a three-D-cell holder are only suggestions.[7]
Good to know
- The manual says to power the set with 4.5 V DC only. The rear jack is marked DC IN 4.5 V. Stock cells are three AA.[2]
- The external plug is coaxial with a positive tip. The voltage tolerance is unknown, so stay at or below 4.5 V.[7] unverified
⚠ Watch out
- The plug size is unconfirmed. A wrong plug or more than 4.5 V is untested.[7] unverified
Guides:No guide found yet.
Remove the keypad beepExperimental
- ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.
One builder silenced the beep by taking out a single capacitor. Which capacitor is shown only in the photos.[5]
Good to know
- The beep mod is removing one capacitor. The part number and value are not stated.[5] unverified
⚠ Watch out
- Match the capacitor to the photos on the build post. The text does not identify it.[5] unverified
Brighter LED backlightExperimental
- ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.
Add a 120 kilohm resistor and a bright LED at pin 10. The existing backlight capacitor stays. The light follows the backlight button, including a short glow with the radio off.[6]
Parts
- 120 kilohm resistor and a bright LED Fits with conditions — The LED goes at pin 10. LED type, polarity and wire path are shown only in the photos, if at all.[6]
Good to know
Sources (7)
- official Sony overseas radio lineup · 2026-11-17
- docs Sony ICF-SW35 operating manual · 2026-11-17
- docs RigPix — Sony ICF-SW35 · 2026-11-17
- wiki ICF-SW35 — Radiomuseum · 2026-11-17
- blog Rolf's Sony ICF-SW35 mod removes the beep sound · 2026-11-17
- blog Rolf's LED backlight mod for the Sony ICF-SW35 · 2026-11-17
- blog An external battery pack for the Sony ICF-SW35? · 2026-11-17