Home › Devices › Canon › Canon EOS 6D
CANON · CAMERA · 2012
Canon EOS 6D
Also called: EOS 6D · 6D · EOS 6D WG · EOS 6D N
Canon's entry full-frame DSLR with DIGIC 5+. Two versions: WG (Wi-Fi and GPS) and N (neither). Magic Lantern runs from the SD card and targets Canon firmware 1.1.6. iFixit documents LCD, top screen, panel, and sensor repairs.[1][11][3][4]
Which one do I have?
| Model | Variant | Year | Firmware | How to tell |
|---|---|---|---|---|
| EOS 6D (WG) | Wi-Fi and GPS | 2012 | 1.1.6 | First Canon DSLR with GPS and built-in Wi-Fi. Canon publishes separate Wi-Fi and GPS manuals for the WG. GPS can drain the battery if left on while the camera is off.[1][2][3] |
| EOS 6D (N) | no Wi-Fi or GPS | 2012 | 1.1.6 | Same body without Wi-Fi or GPS. Uses the same 1.1.6 firmware line as the WG.[1][3] |
Specs
Mods (6)
⚠ Mod at your own risk. We collect what others have published; we have not tested these mods. Read the safety notes
Magic LanternWorks
- ⚠ Can brick A mistake can leave the device unable to start.
- ⚠ Data loss Can erase what is on the device. Back up first.
Free GPL add-on from the SD card. It targets Canon firmware 1.1.6 on the 6D. EOSHD puts the 6D in the mid-range raw-video class (~40 MB/s SD).[9][11][12][10][3][8][13]
Parts
- SD or SDHC card, 32 GB or smaller Fits — Used for a first Magic Lantern install.[11]
Good to know
- Magic Lantern runs from the card as an add-on over standard Canon firmware. It does not replace firmware in ROM.[12][10]
- Wikipedia lists the 6D among Magic Lantern supported cameras. The shared platform listing uses 6D.116.[9][10]
- Canon firmware 1.1.6 is for cameras on 1.1.4 or earlier. Cameras already on 1.1.6 do not need the update.[3]
- EOSHD puts the 6D in the mid-range raw class with about 40 MB/s SDHC class 10 cards, with 10-bit full-frame modes among the options tested.[8]
- Hold SET at startup to bypass Magic Lantern for one session. Full uninstall runs Firmware Upgrade in-camera to clear the boot flag.[12]
⚠ Watch out
- Match the Magic Lantern build to Canon firmware 1.1.6, and follow the install guide.[3][11]
- The project warns that Magic Lantern can damage or destroy the camera.[11]
- First install: card of 32 GB or smaller and a fully charged original battery.[11]
- Canon does not cover repairs caused by third-party firmware.[13]
Guides:Magic Lantern INSTALL.txt
Replace the LP-E6 batteryWorks
- ⚠ Lithium battery Uses or touches a lithium cell. A damaged cell can catch fire.
The camera takes an LP-E6 pack (about 1800 mAh). A BG-E13 grip takes six AA cells or one or two LP-E6 packs. On the WG, GPS can drain the pack if left on while the camera is off.[1]
Parts
- Canon LP-E6 Fits — Standard Li-Ion pack, about 1800 mAh.[1]
- Battery Grip BG-E13 Fits — Takes six AA cells or one or two LP-E6 packs.[1]
Good to know
- Battery is Li-Ion LP-E6, rated about 1800 mAh.[1]
- BG-E13 allows six AA cells or one or two LP-E6 batteries.[1]
- On the WG, GPS stays on when the camera is off and drains the battery unless turned off in settings.[1]
Guides:No guide found yet.
Rear LCD replacementWorks
- ⚠ Stored charge Capacitors keep a dangerous charge after the device is off.
iFixit guide for a cracked or failed rear LCD. Starts at the viewfinder cover and battery door, then screws and the ribbon.[4]
Special tools: Phillips #00 screwdriver, spudger, tweezers
Good to know
Top status screen replacementWorks
- ⚠ Stored charge Capacitors keep a dangerous charge after the device is off.
iFixit guide for the top analog status screen. Early steps remove the HDMI/AV/MIC port covers.[5]
Good to know
Front and top body panelsWorks
- ⚠ Stored charge Capacitors keep a dangerous charge after the device is off.
iFixit guide to replace the front or top body panels and reach internal parts. About 50 minutes, moderate.[6]
Good to know
Image sensor replacementWorks
- ⚠ Stored charge Capacitors keep a dangerous charge after the device is off.
- ⚠ Permanent change Cuts, drills or glues the device. You cannot undo it.
iFixit 35-step sensor swap, about one hour. Commenters warn that removing the CMOS without calibration can ruin focus.[7]
Good to know
- iFixit covers replacing a malfunctioning image sensor: about 1 hour, moderate rating, 35 steps.[7]
⚠ Watch out
- A commenter warns that removing the CMOS sensor as shown can render the camera useless without precise calibration.[7]
Buttons & modes
| What | How |
|---|---|
| Bypass Magic Lantern once | Hold SET at startup.[12] |
Sources (13)
- wiki Canon EOS 6D - Wikipedia · 2026-11-16
- official EOS 6D (WG) Wi-Fi and GPS Function Instruction Manuals · 2026-11-16
- news Canon EOS 6D Firmware 1.1.6 Released · 2026-11-16
- docs Canon EOS 6D Rear LCD Screen Replacement · 2026-11-16
- docs Canon EOS 6D Analog Screen Replacement · 2026-11-16
- docs Canon EOS 6D Front and Top Body Panel Replacement · 2026-11-16
- docs Canon EOS 6D Image Sensor Replacement · 2026-11-16
- blog Magic Lantern Raw Video - Current camera capabilities · 2026-11-16
- wiki Magic Lantern (firmware) - Wikipedia · 2026-11-15
- official magiclantern_simplified - reticulatedpines · 2026-11-15
- official Magic Lantern INSTALL.txt · 2026-11-15
- official Magic Lantern FAQ.txt · 2026-11-15
- blog Will Custom Firmware Void My Warranty? · 2026-11-15