★ 155 device pages approved★ 1835 sources cited★ Every fact links to its source★ Send us your build log★ No ads. Some part links may earn us a commission.★ 155 device pages approved★ 1835 sources cited★ Every fact links to its source★ Send us your build log★ No ads. Some part links may earn us a commission.
mods for old iconic tech · est. 2026
0000161devices tracked

Home › Devices › Canon › Canon EOS 6D

[ device photo ]NEW!

CANON · CAMERA · 2012

Canon EOS 6D

Also called: EOS 6D · 6D · EOS 6D WG · EOS 6D N

✔ APPROVEDChecked fact by fact · last checked 2026-11-16 · 13 sources

Canon's entry full-frame DSLR with DIGIC 5+. Two versions: WG (Wi-Fi and GPS) and N (neither). Magic Lantern runs from the SD card and targets Canon firmware 1.1.6. iFixit documents LCD, top screen, panel, and sensor repairs.[1][11][3][4]

6MODS
6WORK
0EXPERIMENTAL
13SOURCES

Which one do I have?

MODELS.TXT
ModelVariantYearFirmwareHow to tell
EOS 6D (WG)Wi-Fi and GPS20121.1.6First Canon DSLR with GPS and built-in Wi-Fi. Canon publishes separate Wi-Fi and GPS manuals for the WG. GPS can drain the battery if left on while the camera is off.[1][2][3]
EOS 6D (N)no Wi-Fi or GPS20121.1.6Same body without Wi-Fi or GPS. Uses the same 1.1.6 firmware line as the WG.[1][3]
Specs
ProcessorDIGIC 5+[1]
BatteryLP-E6, about 1800 mAh[1]
StorageSingle SD / SDHC / SDXC, UHS-I[1]
Screen3.0-inch rear LCD, 720×480[1]

Mods (6)

⚠ Mod at your own risk. We collect what others have published; we have not tested these mods. Read the safety notes

Magic LanternWorks
SoftwareDifficulty: mediumCase stays closedNo solderingReversible
  • ⚠ Can brick A mistake can leave the device unable to start.
  • ⚠ Data loss Can erase what is on the device. Back up first.

Free GPL add-on from the SD card. It targets Canon firmware 1.1.6 on the 6D. EOSHD puts the 6D in the mid-range raw-video class (~40 MB/s SD).[9][11][12][10][3][8][13]

Parts

  • SD or SDHC card, 32 GB or smaller Fits — Used for a first Magic Lantern install.[11]

Good to know

  • Magic Lantern runs from the card as an add-on over standard Canon firmware. It does not replace firmware in ROM.[12][10]
  • Wikipedia lists the 6D among Magic Lantern supported cameras. The shared platform listing uses 6D.116.[9][10]
  • Canon firmware 1.1.6 is for cameras on 1.1.4 or earlier. Cameras already on 1.1.6 do not need the update.[3]
  • EOSHD puts the 6D in the mid-range raw class with about 40 MB/s SDHC class 10 cards, with 10-bit full-frame modes among the options tested.[8]
  • Hold SET at startup to bypass Magic Lantern for one session. Full uninstall runs Firmware Upgrade in-camera to clear the boot flag.[12]

⚠ Watch out

  • Match the Magic Lantern build to Canon firmware 1.1.6, and follow the install guide.[3][11]
  • The project warns that Magic Lantern can damage or destroy the camera.[11]
  • First install: card of 32 GB or smaller and a fully charged original battery.[11]
  • Canon does not cover repairs caused by third-party firmware.[13]

Guides:Magic Lantern INSTALL.txt

Replace the LP-E6 batteryWorks
BatteryDifficulty: easyCase stays closedNo solderingReversible
  • ⚠ Lithium battery Uses or touches a lithium cell. A damaged cell can catch fire.

The camera takes an LP-E6 pack (about 1800 mAh). A BG-E13 grip takes six AA cells or one or two LP-E6 packs. On the WG, GPS can drain the pack if left on while the camera is off.[1]

Parts

  • Canon LP-E6 Fits — Standard Li-Ion pack, about 1800 mAh.[1]
  • Battery Grip BG-E13 Fits — Takes six AA cells or one or two LP-E6 packs.[1]

Good to know

  • Battery is Li-Ion LP-E6, rated about 1800 mAh.[1]
  • BG-E13 allows six AA cells or one or two LP-E6 batteries.[1]
  • On the WG, GPS stays on when the camera is off and drains the battery unless turned off in settings.[1]

Guides:No guide found yet.

Rear LCD replacementWorks
RepairDifficulty: mediumOpens caseNo solderingReversible
  • ⚠ Stored charge Capacitors keep a dangerous charge after the device is off.

iFixit guide for a cracked or failed rear LCD. Starts at the viewfinder cover and battery door, then screws and the ribbon.[4]

Special tools: Phillips #00 screwdriver, spudger, tweezers

Good to know

  • iFixit covers replacing a cracked or malfunctioning rear LCD on the EOS 6D.[4]
  • Removal starts with the viewfinder cover, then the battery door, then several screws.[4]

Guides:Canon EOS 6D Rear LCD Screen Replacement

Top status screen replacementWorks
RepairDifficulty: mediumOpens caseNo solderingReversible
  • ⚠ Stored charge Capacitors keep a dangerous charge after the device is off.

iFixit guide for the top analog status screen. Early steps remove the HDMI/AV/MIC port covers.[5]

Good to know

  • iFixit covers replacing a cracked or malfunctioning top analog screen.[5]
  • An early step removes covers for the HDMI/AV/MIC ports on the side.[5]

Guides:Canon EOS 6D Analog Screen Replacement

Front and top body panelsWorks
RepairDifficulty: mediumOpens caseNo solderingReversible50 min
  • ⚠ Stored charge Capacitors keep a dangerous charge after the device is off.

iFixit guide to replace the front or top body panels and reach internal parts. About 50 minutes, moderate.[6]

Good to know

  • Guide covers the front and top body panels and access to damaged internal components.[6]
  • Time required about 50 minutes, difficulty moderate.[6]

Guides:Canon EOS 6D Front and Top Body Panel Replacement

Image sensor replacementWorks
RepairDifficulty: expertOpens caseNo solderingPermanent1 hour
  • ⚠ Stored charge Capacitors keep a dangerous charge after the device is off.
  • ⚠ Permanent change Cuts, drills or glues the device. You cannot undo it.

iFixit 35-step sensor swap, about one hour. Commenters warn that removing the CMOS without calibration can ruin focus.[7]

Good to know

  • iFixit covers replacing a malfunctioning image sensor: about 1 hour, moderate rating, 35 steps.[7]

⚠ Watch out

  • A commenter warns that removing the CMOS sensor as shown can render the camera useless without precise calibration.[7]

Guides:Canon EOS 6D Image Sensor Replacement

Buttons & modes

BUTTONS.TXT
WhatHow
Bypass Magic Lantern onceHold SET at startup.[12]

Sources (13)

SOURCES.TXT