Home › Devices › Apple › iPod 4th gen (click wheel)
APPLE · MUSIC PLAYER · 2004-2005
iPod 4th gen (click wheel)
Also called: iPod Click Wheel · iPod 4G grayscale · iPod 4th generation · A1059 · M9282 · M9268 · U2 Special Edition iPod 4G
Monochrome click-wheel iPod with a 20 GB or 40 GB hard drive. Common upgrades swap the drive for flash (iFlash or microSD adapters), replace the battery, and install Rockbox. The color Photo / Color models are on a separate page.[1][2][11][18]
Which one do I have?
| Model | Variant | Year | Firmware | How to tell |
|---|---|---|---|---|
| A1059 | 20 GB | 2004 | iPod OS 3.1.1 | Back reads A1059 (EMC 1995). Order number M9282LL/A. Monochrome 2-inch screen and click wheel. Introduced 19 July 2004.[1][2][3] |
| A1059 | 40 GB | 2004 | iPod OS 3.1.1 | Same A1059 case as the 20 GB. Order number M9268LL/A. Discontinued 23 February 2005.[1][2] |
| A1059 | U2 Special Edition | 2004 | iPod OS 3.1.1 | Order number M9787LL/A, introduced 26 October 2004. Same monochrome 4th gen hardware with U2 Special Edition finish.[2] |
Specs
| Screen | 2-inch grayscale LCD, 160×128, blue-white LED backlight[1] |
| Drive | 20 GB or 40 GB, 4200 RPM ATA-66; 32 MB SDRAM[1] |
| Battery | Built-in rechargeable lithium ion; up to 12 hours music (Apple). Low End Mac lists 600 mAh lithium polymer.[2][1][3] |
| Ports | Dock connector: FireWire 400 and USB 2.0; first full-size iPod that charges over USB 2.0[2][3] |
Mods (6)
⚠ Mod at your own risk. We collect what others have published; we have not tested these mods. Read the safety notes
Flash storage (replace the hard drive)Works
- ⚠ Data loss Can erase what is on the device. Back up first.
Swap the spinning drive for an iFlash board with the 4th gen converter ribbon, or for a CE-to-CF plus microSD stack. Uses much less power than the original drive.[11][10][9][12][13][14][15][8][5][16]
Special tools: iPod opening tool, spudger, T6 Torx
Parts
- iFlash-ATA1 Fits with conditions — SD adapter sold for 4th gen Grey Scale/BW and Color/Photo iPods. Its list names the 20 GB M9282 and the U2 M9787; the 40 GB monochrome M9268 is not named.[11] Buy: iflash.xyz
- iFlash 4th Gen Converter ribbon Fits with conditions — Passive 50-pin IDE to 40-pin ZIF ribbon so Solo, Dual, or Quad boards fit. Vendor known-to-work list names the 20 GB M9282; it does not list the 40 GB M9268. Crease along the dashed lines before seating.[9][10] Buy: iflash.xyz
- iFlash-Quad (4× microSD) Fits with conditions — Needs the 4th gen converter ribbon. Thin board leaves room for a larger battery.[12][10][16] Buy: iflash.xyz
- iFlash-Solo (1× SD) Fits with conditions — Needs the 4th gen converter ribbon.[13][10] Buy: iflash.xyz
- CE-to-CF 1.8in adapter + CF-to-microSD Fits with conditions — Community path: microSD into CF adapter into CE-to-CF. Recommend 4–128 GB; some report 256 GB. You may need to remove the HDD connector stopper.[8]
Good to know
- iFlash-ATA1 is sold for 4th gen Grey Scale/BW iPods (and for Photo / Color on their own page).[11]
- A FlashQuad build used a new ribbon cable because 4th gen iPods need one, and formatted cards as FAT32 before install.[16]
- PATA addressing tops out at 127 GB. Track count still depends on RAM and the iTunes database.[16][14]
- Case opens by releasing five retaining tabs on the right edge. The headphone jack ribbon is fragile.[5]
⚠ Watch out
- After a microSD swap, one iFixit guide says plug into a wall charger to finish restore — USB to the computer alone was not enough. Another write-up says USB restore works. Have a wall adapter ready.[8][16]
- SDXC cards of 64 GB and up usually come formatted exFAT. Format them as FAT32 before use.[15][16]
Guides:iPod 4th generation or Photo hard drive replacement by micro SD card - iFixit4th Gen iPod Converter – iFlash.xyziPod 4th Generation or Photo Hard Drive Replacement - iFixit
Rechargeable batteryWorks
- ⚠ Lithium battery Uses or touches a lithium cell. A damaged cell can catch fire.
Open the case, free the headphone cable, unplug the white battery connector, and swap the pack. Same iFixit steps as the Photo model.[4][2]
Special tools: iPod opening tool, spudger, T6 Torx
Good to know
- Remove two T6 Torx screws and lift the hard drive to reach the battery. A spudger may be needed to free the pack from adhesive.[4]
- Apple rates the stock pack for up to 12 hours of music and a full charge of about 4 hours (FireWire fast charge reaches 80% in about 2 hours).[2]
⚠ Watch out
- Do not strain the fragile headphone jack cable while working.[4]
Guides:iPod 4th Generation or Photo Battery Replacement - iFixit
Rockbox custom firmwareWorks
- ⚠ Can brick A mistake can leave the device unable to start.
- ⚠ Data loss Can erase what is on the device. Back up first.
Open-source firmware with a released bootloader and Rockbox Utility support on the 4th gen grayscale iPod. Dual-boot style install; monochrome screen, no video.[18][19]
Good to know
- Rockbox TargetStatus lists iPod 4G among stable targets with released bootloaders and Rockbox Utility support.[18]
- Rockbox is a free open-source replacement that can run beside the original firmware and adds codecs such as FLAC and Vorbis.[19]
Guides:No guide found yet.
Display replacementWorks
Open the case, remove six T6 Torx screws on the logic board, unlock the display and click-wheel connectors, and fit a 4G display.[6][7]
Special tools: iPod opening tool, spudger, T6 Torx
Good to know
- The logic board is held by six black T6 Torx screws. Display and click-wheel connectors use black retaining bars.[6]
- Unlock the click-wheel ribbon before sliding it out.[7][6]
Guides:iPod 4th Generation or Photo Display Replacement - iFixit
Front panel / shellWorks
Replace the plastic front half after disconnecting the hard drive, battery, and unlocking the click-wheel ribbon.[7]
Special tools: iPod opening tool, spudger, T6 Torx
Good to know
- The front panel is the plastic front half of the case. Hard drive and battery connectors come off before the logic board.[7]
Guides:iPod 4th Generation or Photo Front Panel Replacement - iFixit
Large DIY battery packExperimental
- ⚠ Lithium battery Uses or touches a lithium cell. A damaged cell can catch fire.
- ⚠ Soldering Needs a soldering iron. Heat can lift pads and burn skin.
- ⚠ Permanent change Cuts, drills or glues the device. You cannot undo it.
One builder fitted 5000 mAh prismatic cells in a thick back plate after flash conversion, with a thermistor lead and a Molex PicoBlade plug.[17]
Good to know
- The build used 5000 mAh prismatic cells and swapped the cell's JST harness for the iPod Molex PicoBlade plug, with a thermistor lead soldered on.[17]
- Finished weight with flash and the 5 Ah cell was about 6.31 oz versus about 6.42 oz stock.[17]
Guides:No guide found yet.
Sources (19)
- wiki Apple iPod 4th Gen (ClickWheel) 20 GB, 40 GB Specs · 2026-11-17
- official iPod with Click Wheel (20 GB, 40 GB including U2) - Technical Specifications · 2026-11-17
- blog 4th Generation iPod - Low End Mac · 2026-11-17
- docs iPod 4th Generation or Photo Battery Replacement - iFixit · 2026-11-17
- docs iPod 4th Generation or Photo Hard Drive Replacement - iFixit · 2026-11-17
- docs iPod 4th Generation or Photo Display Replacement - iFixit · 2026-11-17
- docs iPod 4th Generation or Photo Front Panel Replacement - iFixit · 2026-11-17
- docs iPod 4th generation or Photo hard drive replacement by micro SD card - iFixit · 2026-11-17
- shop 4th Gen iPod Converter – iFlash.xyz · 2026-11-17
- shop 4th Gen iPod Converter – iFlash.xyz · 2026-11-15
- shop iFlash-ATA1 – iFlash.xyz · 2026-11-15
- shop iFlash-Quad – iFlash.xyz · 2026-11-15
- shop iFlash-Solo – iFlash.xyz · 2026-11-15
- official iFlash-Compatibility – iFlash.xyz · 2026-11-15
- docs Prepare SDXC (ExFat) for use with the iPod – iFlash.xyz · 2026-11-15
- news How to revive an iPod with a hard drive using flash storage | AppleInsider · 2026-11-17
- blog iPod 4th Generation - Flash Storage Upgrade · 2026-11-17
- wiki TargetStatus – Rockbox · 2026-11-15
- wiki Rockbox - Wikipedia · 2026-11-15